Instructions For Use - Otto Bock 4R104-60 Instructions For Use Manual

CAUTION
Exceeding the service life and reuse on another patient
Risk of injury due to loss of functionality as well as damage to the
product
► Ensure that the approved service life is not exceeded.
► Only use the product on a single patient.
CAUTION
Mechanical damage to the product
Risk of injury due to change in or loss of functionality
► Use caution when working with the product.
► If the product is damaged, check it for proper function and readi­
ness for use.
► In case of changes in or loss of functionality, do not continue
using the product (see "Signs of changes in or loss of functional­
ity during use" in this section).
► Take any necessary measures (e.g. repair, replacement, inspec­
tion by the manufacturer's customer service, etc.).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.
4 Scope of delivery
Quantity Designation
1

Instructions for use

1 Double adapter, sliding
Pre-assembled:
8 Set screw
1 Set screw
2 Cap screw
Reference number
–
–
506G3=M8x16
506G3=M5x8
501Z16
5 Preparing the product for use
CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connec­
tions
► Clean the threads before every installation.
► Apply the specified torque values.
► Follow the instructions regarding the length of the screws and
about how to secure the screws.
5.1 Installation in the modular prosthesis
Adjusting the stop
The set screw in the dovetail guide limits sliding of the adapter in one
direction. For sliding in the opposite direction, the adapter can be
turned or the set screw can be moved.
Required tools: 710D1 torque wrench
>
► CAUTION! Only use the adapter with the set screw screwed
into the dovetail guide.
Make sure that the set screw (see fig. 3) is screwed correctly into
the dovetail guide (tightening torque: 5 Nm).
Connecting the pyramid adapter and pyramid receiver
The pyramid adapter is fixed with the set screws of the pyramid receiv­
er.
Required materials: torque wrench (e.g. 710D20), 636K13 Loc­
>
tite 241
1) Fitting:
Screw in the set screws.
Use the torque wrench to tighten the set screws (10 Nm).
9