Seat; Replacing The Seat Plate (Standard Seat); Replacing The Seat Plate (Vas Seat) - Otto Bock 490E75 Series Service Manual

Service work
4.13

Seat

4.13.1

Replacing the seat plate (standard seat)

Prerequisites:
Switch off the control unit and deactivate the main fuse (see Page 15).
Remove the seat cushion and back padding.
Removing the seat plate (standard seat)
1) Pull the back edge of the seat plate upwards (see Fig. 151).
2) Unhook the seat plate from the front edge and remove it (see Fig. 152, item 1).
NOTICE! Damage to components or cables due to improper removal of the seat plate. Control modules
may be attached to the seat plate. Make sure the modules and cables are not damaged, and remove
them if necessary.
Attaching the seat plate (standard seat)
1) Hook the seat plate onto the front edge (see Fig. 152, item 1).
2) Push the rear edge of the seat plate downwards and engage it securely (see Fig. 151).
151

Replacing the seat plate (VAS seat)

4.13.2
Prerequisites:
Switch off the control unit and deactivate the main fuse (see Page 15).
Remove the seat cushion and back padding.
Tools: Allen wrench size 3, 6; torque wrench with Allen insert size 3, 6
Removing the seat plate (VAS seat)
1) Loosen and remove the 6 outer screws (short) on the seat plate (see Fig. 153, item 1).
2) Loosen and remove the 2 inner screws (long) in the slotted holes of the seat plate (see Fig. 153, item 2).
3) Remove the cover on both bearing plates (see Page 91).
4) Loosen the 2 screws in the bearing plates on both sides (see Fig. 154, item 1).
5) Pull the seat plate forwards and out to remove it. Lift the back slightly if necessary.
NOTICE! Damage to components or cables due to improper removal of the seat plate. Control modules
may be attached to the seat plate. Make sure the modules and cables are not damaged, and remove
them if necessary.
Attaching the seat plate (VAS seat)
1) Slide the seat plate onto the seat frame from the front. Slide the seat plate carefully under the bearing plates as
you do so.
2)
Fig. 153, item 2).
3)
4) Position the back evenly using the markings on the seat plate (see Page 93).
5) Firmly tighten the 2 screws in the bearing plates on both sides to 25 Nm (see Fig. 154, item 1).
6) Install the cover on both bearing plates (see Page 91).
74 | Ottobock
152
4 Nm (see Fig. 153, item 1).
4 Nm (see
490E75=0_C