Table of Contents
Advertisement
Parameter
Setting range
Sounder Volume
0–10
Lock Function
None, se-
Enabled
quence, key,
both
Reverse Driving
Yes, no
Alarm
Emergency Stop
Yes, no
Switch
Power-up Mode
Last used,
drive, seat,
Bluetooth,
external de-
vices, mode 5,
mode 6, IR
mode, pro-
gramming
7.4.2
Speed parameters
The following parameters can be set under Speeds:
Parameter
Setting range
Maximum For-
Single steps
ward Speed
from 0 to 100%
Minimum For-
Single steps
ward Speed
from 0 to 100%
Maximum Rever-
Single steps
se Speed
from 0 to 100%
490E75=0_C
Description
Volume of the acoustic feedback provided when operating a button or a
switch on the joystick module.
When the parameter is set to 0 there is no acoustic feedback. The higher the
value, the louder the beep.
Used to set whether and how the R-Net control unit can be locked to prevent
the wheelchair from being used by unauthorised persons.
The programmable options are as follows:
•
None: means that the R-Net cannot be locked
•
Sequence: means that the R-Net can be locked/unlocked by pressing a
sequence of buttons
•
Key: means that a key provided by the manufacturer can be used to lock/
unlock the R-Net.
•
Both: means that either a sequence of buttons or a key can be used to
lock/unlock the R-Net.
Used to set whether an alarm signal sounds when the wheelchair is driving
in reverse
Used to set whether an emergency stop switch must be used when operati-
on in latched mode is programmed.
When set to Yes, an emergency stop switch (break contact) must be con-
nected to the socket for the input device for the external profile on the joy-
stick module when latched driving or operation of the variable motor in latch
mode is programmed. If no emergency stop switch is installed, operation of
the wheelchair is blocked.
When set to No, no emergency stop switch is required. This setting should
only be used following an analysis of all the associated risks, i.e., no emer-
gency stop can be performed when driving or operating a variable motor in
latched mode.
Ottobock shall not be liable for any losses etc. of any kind resulting from
the use of a wheelchair which is programmed for driving or operation of a
variable motor in latched mode and which has not been installed with an
emergency stop switch.
Used to set the mode which is selected when the system is switched on. If
Last used is selected, the mode which was selected when the wheelchair
was last switched off will be selected when it is next switched on.
If a mode is selected but the corresponding output module is not available,
the system automatically switches to driving mode when the wheelchair is
switched on.
Description
Speed for forward driving of the wheelchair when the joystick is pushed com-
pletely forwards and the highest speed level is set (all 5 bars illuminated).
Speed for forward driving of the wheelchair when the joystick is pushed com-
pletely forwards and the lowest speed level is set (only 1 bar illuminated).
The value of the minimum forward speed cannot be set higher than the value
for the maximum forward speed.
Speed for reverse driving of the wheelchair when the joystick is pushed com-
pletely back and the highest speed level is set (all 5 bars illuminated).
R-Net wheelchair control
Ottobock | 149
Advertisement
Table of Contents
