Replacing The Vr2 Control Panel - Otto Bock 490E75 Series Service Manual

Service work
45
4.8.8

Replacing the VR2 control panel

Prerequisites:
Switch off the control unit and deactivate the main fuse (see Page 15).
Tools: Allen wrench size 3
Removing the VR2 control panel
1) Disconnect the cable of the control panel from the cable extension (see Fig. 46, item 1).
2) Loosen and remove the screws between the control panel rail and control panel (see Fig. 46, item 2).
3) Remove the control panel from the control panel rail.
4) If necessary: Remove and replace the control panel rail (see Fig. 46, item 3).
Installing the VR2 control panel
1) If necessary: Attach the control panel rail in the desired position (see Fig. 46, item 3).
2) Set the control panel onto the control panel rail.
3)
4) Connect the cable of the control panel to the cable extension (see Fig. 46, item 1).
46
34 | Ottobock 490E75=0_C