Seat Parameters; Technical Data; Appendixes; Approved Seat Brackets - Otto Bock 490E75 Series Service Manual

7.4.6

Seat parameters

An actuator function is a seat control function. An actuator function can comprise one actuator motor, e.g. a simple
seat height adjustment, or more than one actuator motor, e.g. adjustment of both footrests at the same time or an
anti-shear seat setting. There are 6 motor channels on the intelligent seat module (ISM) and one function can be
assigned to any number of these channels.
The R-Net control unit can support up to 12 actuator functions. Each of these can be programmed to define which
actuator motor moves as well as what is shown on the display for the user. The relevant parameters are "Function
channels" and "Function display" and are set under Seating/Intelligent Seating Module/Axis Settings.
The following parameters can be set under Seating/Intelligent Seating Module/Global:
Parameter Setting range
Actuator Mode Last used, func-
Entry Axis tion 1 to n
The following parameters can be set for each ISM channel under Seating/Intelligent Seating Module/Channels:
Parameter Setting range
Acceleration 1 to 100 in sing-
le steps
Deceleration 1 to 100 in sing-
le steps
Up Speed 25% to 100%
in single steps
Down Speed 25% to 100%
in single steps
8

Technical data

All technical data for the current wheelchair configuration are found in the current instructions for use (user or qua-
lified personnel). You can request the updated instructions for use for your new configuration from the manufacturer
(see the overview of national Ottobock branches on the inside of the back cover).

Appendixes

9.1

Approved seat brackets

Front-wheel drive (FWD)
Seat height Seat
adjustment/tilt
with module Standard
VAS/Recaro*
without module Standard
VAS/Recaro
* For mobility base size 2 and seat depth ≥ 52 cm, use the 491C75=SS111 seat bracket.
Rear-wheel drive (RWD)
Seat height Seat
adjustment/tilt
with module Standard
VAS/Recaro
without module Standard
VAS/Recaro
490E75=0_C
Description
The desired function can be selected here. If "Last used" is selected, this
means that the function which was last processed in the program is automa-
tically selected when the seat settings are retrieved.
Description
Acceleration rate for a specific ISM channel.
Deceleration rate for a specific ISM channel.
Sets the speed of an ISM channel in the upward direction.
Sets the speed of an ISM channel in the downward direction.
Approved seat brackets
491C75=SS101; 491C75=SS102; 491C75=SS128
491C75=SS101; 491C75=SS102; 491C75=SS215
491C75=LS126; 491C75=RS126; 491C75=LS127; 491C75=RS127
491C75=SS101; 491C75=SS102; 491C75=SS205
Approved seat brackets
491C75=SS111; 491C75=SS112; 491C75=SS128
491C75=SS111; 491C75=SS112; 491C75=SS215
491C75=LS126; 491C75=RS126; 491C75=LS127; 491C75=RS127
491C75=SS111; 491C75=SS112; 491C75=SS205
Technical data
Ottobock | 155