Cockpit App; System Requirements; Initial Connection Between Cockpit App And Prosthesis - Otto Bock Genium X3 Series Instructions For Use Manual

9 Cockpit app

INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more
information, please visit the website: http://www.ottobock.com/cockpitapp. To download the
Cockpit app, the QR code on the supplied Bluetooth PIN card can be read with the mobile
device (requirement: QR code reader and camera).
INFORMATION
The language of the Cockpit app user interface can only be changed by the prosthetist using the
adjustment software.
INFORMATION
The serial number of the component to be connected has to be registered with Ottobock the
first time it is connected. If the registration is not accepted, use of the Cockpit app for this com­
ponent will be limited.
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to establish
a connection. If required, Bluetooth on the prosthesis can be switched on permanently after­
wards (see Page 87).

9.1 System Requirements

The functioning of the Cockpit app is assured on devices that support the following operating sys­
tems:
Only when "DUAL" marking is not present (see Page 60)
Android: version 4.0.3 or higher
•
Only when "DUAL" marking is present (see Page 60)
• The 4X441=* Cockpit app must be installed in version 2.0 or higher
Android: version 4.1 or higher
•
iOS (for iPhone, iPad, iPod): version 9.3 or higher. The mobile device has to support
•
Bluetooth 4.0 (BT LE).

9.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on (see Page 87).
• Bluetooth of the device must be switched on.
76
The cockpit app enables switching from basic mode into the pre-configured
MyModes. In addition, information about the product (step counter, battery
charge level, etc.) can be called up.
The behaviour of the product can be changed to a certain extent on a day-to-
day basis using the app (e.g. while becoming accustomed to the product). At
the next appointment, the prosthetist can trace the changes using the adjust­
ment software.