Safety Instructions - HBM CMA Series Operating Manual

Safety instructions

1 Safety instructions
Appropriate use
The device is to be used exclusively for measurement tasks and directly
related control tasks within the application limits detailed in the specifications.
Use for any purpose other than the above is deemed to be non‐designated
use.
Any person instructed to carry out installation, commissioning or operation of
the device must have read and understood the Operating Manual and in
particular the technical safety instructions.
In the interests of safety, the device should only be operated by qualified
personnel and as described in the Operating Manual. It is also essential to
comply with the legal and safety requirements for the application concerned
during use. The same applies to the use of accessories.
The device is not intended for use as a safety component. Please also refer to
the section: "Additional safety precautions". Proper and safe operation requires
proper transportation, correct storage, siting and mounting, and careful
operation.
Operating conditions
S Protect the device from direct contact with water.
S Protect the device from moisture and weather such as rain or snow. The
protection class according to DIN EN 60529 is IP65 when all cables are
connected and unused connections are fitted with protective caps.
S Do not expose the device to direct sunlight.
S The device connection cables must only be installed inside buildings, and
must not exceed 30 m in length.
S Comply with the maximum permissible ambient temperatures and the data
on maximum humidity as stated in the specifications.
S The device must not be modified from the design or safety engineering
point of view except with our express agreement. In particular, any repair or
soldering work on motherboards (exchanging components) is prohibited.
When exchanging complete modules, use only original parts from HBM.
4
A02559_04_YI0_01 HBM: public
CMA