Safety Instructions - HBM K-LK1/600N-WH Mounting Instructions

1

Safety Instructions

K-LK1/600N-WH
Intended use
The type series K-LK1/600N-WH special force trans­
ducers are solely designed for measuring static and dy­
namic tensile and compressive forces within the load lim­
its specified by the technical data for the respective
maximum load capacities. Any other use is not appropri­
ate.
To ensure safe operation, it is essential to comply with
the regulations in the mounting instructions, the safety
requirements listed below, and the data specified in the
technical data sheets. It is also essential to observe the
applicable legal and safety regulations for the relevant
application.
The force transducers are not intended for use as safety
components. Please also refer to the "Additional safety
precautions" section.
Proper and safe operation of force transducers requires
proper transportation, correct storage, setup and mount­
ing, and careful operation.
Load carrying capacity limits
The information in the technical data sheets must be
complied with when using force transducers. The re­
spective specified maximum loads in particular must
never be exceeded. The following limits set out in the
technical data sheets must not be exceeded:
S Limit forces
S Lateral limit forces
S Breaking forces
S Permissible dynamic loads
A4303-1.0 HBM: public
Safety Instructions
3