12
SERVICE WORK ON THE CHASSIS
12.5
Loosening the fork protection
12.6
Positioning the fork protection
12.7
Removing the fork legs
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on
the brake discs.
–
–
Clean and oil the dust boots and inner fork tube of both fork legs.
Universal oil spray (
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Position the fork protection. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Push the fork protection downwards.
L02631-10
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
L02631-11
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove the cable binder(s).
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
Info
Do not pull the hand brake lever when the front wheel is removed.
M00365-10
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
p. 123)
p. 44)
and take off the clamp.
on the left fork leg. Push the fork protection downwards.
(
p. 76)
and take off the clamp.
and take off the brake caliper.
p. 43)
M6
10 Nm (7.4 lbf ft)
.
M6
10 Nm (7.4 lbf ft)
p. 83)
p. 43)
44
.