Loosening The Fork Protection; Positioning The Fork Protection; Removing The Fork Legs - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.5

Loosening the fork protection

11.6

Positioning the fork protection

11.7

Removing the fork legs

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on
the brake discs.
–
–
Clean and oil the dust boots and inner fork tube of both fork legs.
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Position the fork protection. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Push the fork protection downwards.
B01849-10
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line. Position the clamp and mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B01849-11
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not activate the hand brake lever while the front wheel is removed.
B00300-10
–
Unscrew screws
–
Unscrew screws
L01911-10
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
p. 34)
1 and take off the clamp.
2
on the left fork leg. Push the fork protection downwards.
( p. 65)
x
1
and take off the clamp.
2 and take off the brake caliper.
3
. Take out the left fork leg.
4 . Take out the right fork leg.
p. 33)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 33)
34
1 .
2
.