Checking The Damper - Husqvarna FE 450 2014 Repair Manual

9 SHOCK ABSORBER, SWINGARM
9.18
62
200798-10

Checking the damper

201402-10
201403-10
-
Lubricate the special tool.
Shock absorber fluid (SAE 2.5) (50180751 S1)
Calibrating unit (T1205) (�
-
Support seal ring retainer
tool.
I Mounting tool (T150S) (�
-
Press the special tool through the new pilot bushing.
I Calibrating unit (T1205)
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the seal ring retainer.
Condition
The damper has been disassembled.
-
Measure the inside diameter on both ends and in the middle
of the damper cartridge.
Damper cartridge
Diameter
If the measured value is greater than the specified value:
-
Change the damper cartridge.
-
Check the damper cartridge for damage and wear.
If there is damage or wear:
-
Change the damper cartridge.
-
Check the heim joint for damage and wear.
If there is damage or wear:
-
Change the heim joint.
-
Measure the diameter of the piston rod.
Piston rod
Diameter
If the measured value is less than the specified value:
-
Change the piston rod.
-
Measure the run-out of the piston rod.
Piston rod
I
Run-out
If the measured value is greater than the specified value:
-
Change the piston rod.
-
Check the piston rod for damage and wear.
If there is damage or wear:
-
Change the piston rod.
(l!t! p. 307)
p. 322)
with sleeve of the special
8
t)
p. 325)
(� p. 322)
(� p. 64)
s; 50.08 mm (:5 1.9716 in)
� 17.95 mm(� 0.7067 in)
I s; 0.02 mm (:5 0.0008 in)