Table of Contents
Advertisement
9 SHOCK ABSORBER, SWINGARM
9.18
66
Checking the dam�er
G02061-10
-
Slide the new pilot bushing
I Pressing tool (T1504)
(a
Position the pilot bushing in the seal ring retainer using the
special tool.
I Pressing tool (T1504)
(a
-
Support seal ring retainer
tool. Press the pilot bushing all the way in.
I Mounting tool (T150S)
(a
-
Lubricate the special tool.
Shock absorber fluid (SAE 2.5) (50180751 S1)
Calibrating unit (T1205)
-
Support seal ring retainer
tool.
I Mounting tool (T150S)
(a
-
Press the special tool through the new pilot bushing.
I Calibrating unit (T1205)
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the seal ring retainer.
Condition
The damper has been disassembled.
-
Measure the inside diameter on both ends and in the middle
of the damper cartridge.
Damper cartridge
Diameter
If the measured value is greater than the specified value:
-
Change the damper cartridge.
-
Check the damper cartridge for damage and wear.
If there is damage or wear:
-
Change the damper cartridge.
-
Check the heim joint for damage and wear.
If there is damage or wear:
-
Change the heim joint.
O
onto the special tool.
p. 299)
p. 299)
8
9
with sleeve
of the special
p. 300)
(a
p. 281)
(a
p. 296)
8
9
with sleeve
of the special
p. 300)
(a
p. 296)
(a
p. 69)
:,; 50.08 mm (:,; 1.9716 in)
Advertisement
Table of Contents
