Removing The Stator And Ignition Pulse Generator; Installing The Stator And Ignition Pulse Generator - Husqvarna FE 250 EU 2014 Repair Manual

22
IGNITION SYSTEM
Stator winding - check for a short circuit to ground (terminal 31)
Measure the resistance between the specified points.
Stator, connector
I
Resistance
If the value displayed does not meet specifications:
-
Change the stator.
Removin the stator and i nition pulse enerator
22.4
22.5
EZ
601211-10
- Measuring point
EZ pin 1 Ground
Condition
The alternator cover has been removed.
-
Remove screw
-
Remove retaining bracket.
-
Remove screw
-
Remove cable support sleeve
Remove the stator and ignition pulse generator from the alternator cover.
306640-10
-
Blow out oil nozzle
Guideline
Oil nozzle for alternator
cooling
-
Position the stator and ignition pulse generator in the alternator cover.
-
Mount and tighten screws
Guideline
Screw, stator
-
Position retaining bracket.
-
Mount and tighten screws
Guideline
306640-11
Screw, crankshaft posi­
tion sensor
-
Position cable support sleeve
(-)
O .
8.
8
from the alternator cover.
O
with compressed air and check that it is clear.
M4
8.
M5
8 .
M5
8
in the alternator cover.
2Nm
Loctite ® 243
(1 .5 lbf ft)
6Nm Loctite 243
®
(4.4 lbf ft)
6Nm Loctite 243
®
(4.4 lbf ft)
203
™
™
™