7 HANDLEBAR,CONTROLS
7.1
46
Handlebar �osition
H01188-10
Ad"usting the handlebar �osition
Warning
A repaired handlebar poses a safety risk.
Danger of accidents
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
-
Change the handlebar if the handlebar is damaged or bent.
fl-0
o-e
0-----ca e-e
0
�01189-11
The holes on the handlebar supports are placed at a distance
6)
of
from the center.
I
I
Hole distance A
3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Preparatory work
-
Remove the handlebar cushion.
Main work
O.
-
Remove screws
Take off the handlebar clamp. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam
age.
Do not kink the cables and lines.
8.
-
Remove screws
Take off handlebar supports@).
-
Position rubber bushings
below.
-
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
-
Mount and tighten screws
Guideline
Screw, handle-
M10
bar support
-
Position handlebar.
•
Info
I
Make sure the cables and wiring are positioned cor
rectly.
-
Position the handlebar clamp.
O
-
Mount screws
but do not tighten yet.
8
0
and push through nuts
8.
40 Nm (29.5 lbf ft)
®
Loctite
from
243
™