Table of Contents
Advertisement
•-
C,
-
Check needle bearings
If there is damage or wear:
-
Change the needle bearings.
-
Check spacers (3 and @ for damage and wear.
If there is damage or wear:
-
Change the spacers.
-
Check the shaft seal rings for damage and wear.
If there is damage or wear:
-
Change the shaft seal rings.
SHOCK ABSORBER, LINK FORK 9
-•
0
and
for damage and wear.
-
Check dimension f).
I
54.91 ... 55.00 mm (2.1618 ... 2.1654 in)
If dimension f) is below the specified value:
-
Add the necessary spacing washers
-
Position the angle lever.
-
Mount fitting
Guideline
Nut, angle lever to
link fork
303096-10
8
but do not tighten yet.
M14x1 .5
80 Nm (59 lbf ft)
@).
63
Advertisement
Table of Contents
