Crankshaft Speed Sensor; Speed Sensor - Husqvarna FC 250 2017 Repair Manual

21 IGNITION SYSTEM
Stator winding - check for short circuit to ground (terminal 31)
I
Resistance
21.4
21.5
258
1
�6.3mm
P00023-10
Measure the resistance between the specified points.
Alternator, connector
CR
If the displayed value does not equal the setpoint value:
Replace the stator.
Removing the stator and crankshaft s eed sensor
Installing the stator and crankshaft s�eed sensor
D00201-10
CR
pin - Measuring point Ground, wiring harness/frame
1
I
oo Q
Condition
The alternator cover has been removed.
Remove screws
Remove the retaining bracket.
Remove screws
Remove rubber grommet
Remove the stator and crankshaft speed sensor from the
alternator cover.
Blow out oil nozzle
is clear.
Guideline
Oil nozzle for
alternator cool-
ing
O.
8.
fD
from the alternator cover.
O
with compressed air and check that it
M4 2 Nm (1.5 lbf ft)
®
Loctite 243
™