Husqvarna FC 250 2017 Repair Manual page 255

(D
-
Pull oil filter
I
Lock ring plier (51012011000)
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing surfaces.
-
Lay the motorcycle on its side and fill the oil filter housing to
about½ full with engine oil.
-
Fill the oil filter with engine oil and position the oil filter in the
housing.
-
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover @.
-
Mount and tighten the screws.
Guideline
I
Screw, oil filter cover
-
Stand the motorcycle upright.
-
Remove filler plug
O-ring, and fill up with engine oil.
Engine oil
• Info
I
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
401955-12
-
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning
inhaling them may result in unconsciousness and
death.
-
Always make sure there is sufficient ventilation
when running the engine.
-
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
-
Start the engine and check for tightness.
Finishing work
-
Check the engine oil level.
LUBRICATION SYSTEM
out of the oil filter housing.
p. 296)
(a
I
M6 110 Nm (7.4 lbf ft)
(D
from the clutch cover together with the
Engine oil
1 .0 I (1 .1 qt.)
(SAE 1 OW /50)
(0
Exhaust gases are toxic and
(a p. 250)
p. 290)
..
253
20