17 .4.33
Checking the clutch
•-
-
Check clutch throw-out
If there is damage or wear:
-
Change the clutch push rod.
8
-
Check axial bearing
for damage and wear.
If there is damage or wear:
-
Change the axial bearing.
-
Place the clutch push rod
If there is run-out:
-
Change the clutch push rod.
-
Check the length of clutch springs
I Clutch spring - length
If the clutch spring length is shorter than specified:
-
Change all clutch springs.
-
Check the contact surface of clutch pressure cap
If there is damage or wear:
-
Change the clutch pressure cap.
(D
-
Check clutch basket
If there is damage or wear:
-
Change the clutch basket.
-
Check needle bearing @ and collar sleeve
If there is damage or wear:
-
Change the needle bearing and collar sleeve.
-
Check intermediate clutch discs
If the intermediate clutch discs are not level and are pitted:
-
Change all intermediate clutch discs.
-
Check clutch facing discs Gi) for discoloration and scoring.
If there is discoloration or scoring:
-
Change all clutch facing discs.
O
for damage and wear.
(D
on a flat surface and check for run-out.
C,.
0
for damage and wear.
@)
for damage and wear.
@)
G,
and
for damage and wear.
-•
310351-10
I �
38.5 mm (� 1.516 in)
for damage and wear.
ENGINE 17
209