Removing The Heim Joint - Husqvarna FC 250 2017 Repair Manual

9.19
Removing the heim "oint
SHOCK ABSORBER, LINK FORK 9
-
Measure the diameter of the piston rod.
Piston rod
Diameter
If the measured value is less than the specified value:
-
Change the piston rod.
-
Measure the run-out of the piston rod.
Piston rod
I
Run-out
B04409-10
If the measured value is greater than the specified value:
-
Change the piston rod.
-
Check the piston rod for damage and wear.
If there is damage or wear:
-
Change the piston rod.
-
Check the piston rings for damage and wear.
If damage or a bronze-colored surface is visible:
-
Change the piston.
B04410-10
Condition
The shock absorber has been removed.
-
Clamp the shock absorber into the vise.
Guideline
I
Use soft jaws.
-
Remove both collar bushings
cial tool.
I
Drift (T120) (0
-
Press the heim joint against a lock ring using the special tool.
I
Pressing tool (T1207S)
Remove second lock ring
;:: 17.95 mm(;,: 0.7067 in)
I �
0.02 mm (� 0.0008 in)
of the heim joint with a spe­
O
p. 306)
(0 p. 307)
8.
71