Filling The Cutterbar Lubricant - MacDon R85 Operator's Manual

Filling the Cutterbar Lubricant

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine: stop engine, remove
key, and engage safety props before going under machine for any reason.
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
1. Park the machine on level ground, raise header fully.
2. Stop the engine and remove the key.
3. Engage header safety props.
4. Move higher block to right end of header.
NOTE: Having the fill end higher allows for
quicker filling of cutterbar.
5. Disengage header safety props.
6. Start windrower and lower header onto blocks.
7. Stop the engine and remove the key.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
8. Verify that drain plug (A) has been installed, before
adding new lubricant.
169455
MAINTENANCE AND SERVICING
115
Figure 7.18
Figure 7.19
Rev. E