Table of Contents
Advertisement
2.5.6.
On-board Fan Connector
The fan connector powers, controls and monitors an external fan. To connect a standard 3-pin connector fan to the
module, use Kontron's fan cable, see Table 4: Accessories.
Figure 5: Fan Connector 3-Pin
1
1
3-pin fan connector
Table 11: Fan Connector (3-Pin) Pin Assignment
Pin
Signal
1
Fan_Tach_IN#
2
V_FAN
3
GND
If the input voltage is below or equal to 13 V, then the maximum supply current to the on-board fan connector is
350 mA. The maximum supply current reduces to 150 mA if the input voltage to the module is between 13 V and 20 V.
Always check the fan specification according to the limitations of the supply current and
supply voltage.
2.6. Environmental Specification
The COMe-cEL6 supports two temperature grades commercial and Industrial (E2). The industrial temperature grade
modules support an integrated heatspreader. For temperature grade information, see Chapter 2.1: Module Variants.
Table 12: Temperature Grades and Humidity Specification
Temperature Grades
Commercial Grade
Industrial Grade (E2)
Relative Humidity
www.kontron.com
Description
Fan Input voltage from COMe connector
12 V ±10% (max.) across module input range
Power GND
Operating
0°C to +60°C
-40°C to +85°C
93 % , at +40°C, noncondensing
COMe-cEL6 - User Guide, Rev.1.2
Non-operating (Storage)
-30°C to +85°C
-40°C to +85°C
Type
Input
PWR
PWR
// 32
Advertisement
Table of Contents
