Sata; Ethernet Lan - Kontron COMe-cEL6 User Manual

The following table lists the USB 2.0 port connections
COMe Connector
PCH USB
Port
USB0 USB2_0
USB1 USB2_1
USB2 USB2_2
USB3 USB2_3
USB4 USB2_4
USB5 USB2_5
USB6 USB2_6
USB7 USB2_7
[1]
Use BIOS settings to enable a change between client and host mode and restart

2.3.9. SATA

The COMe-cEL6 supports two SATA high-speed storage interface (6 Gb/s) lanes.
The following table lists the SATA connector connections
COMe Connector HSIO lane #
SATA0 10
SATA1 11
2.3.10.

Ethernet LAN

The COMe-cEL6 supports one Ethernet port with 1 Gb/s or on request up to 2.5 Gb/s.
The main Ethernet PHY features are:
 Full and half duplex 10Base-T(e), 100Base-T, 1000Base-T and on request 2.5 GBase-T
 Precise time stamping according to IEEE 1588 V2 and Synchronous Ethernet (SyncE)
 Smart AZ for legacy MAC to support IEEE 802.3az power saving in idle mode
 Auto MDI/MDI-X and auto polarity correction
 Wake on LAN (WOL)
 Jumbo frame up to 10 KB
 Auto down for Cat3 (four-wire) or bad cable
The following table lists the Ethernet port connections
COMe Connector HSIO lane #
GBE0_MDI[0:3] 7
For 2.5 GbE Ethernet port speed, Intel recommends the use of a compatible connector.
www.kontron.com
Description
USB 2.0 port
USB 2.0 port
USB 2.0 port
USB 2.0 port
USB 2.0 port
USB 2.0 port
USB 2.0 port
Dual role Client/Host, with one endpoint supported
HSIO Port Description
SATA#0 SATA Gen 3, 6 Gb/s to COMe
SATA#1 SATA Gen 3, 6 Gb/s to COMe
HSIO Port Description
GBE#0 10/100/1000 Base-T or 2.5 GBase-T
COMe-cEL6 - User Guide, Rev.1.2
[1]
// 23