Kontron COMe-cEL6 User Manual page 78

Sub-screen Next Level Sub-screens / Description
System Agent Memory
Configuration>
(SA)
(continued)
Configuration>
(continued)
www.kontron.com
Memory Memory Power
Thermal and Thermal
Configuration> Throttling>
(continued) (continued)
Memory Thermal
Management>
Read only field
Memory configuration: RC Version, Date rate and Timings.
Slot information (populate (size, rank, manufacturer), not populated)
Memory ratio and clocking/overclocking
MCR ULT Safe MCR ULT safe Configuration for P0
Config.>
[Enabled, Disabled]
Used for changes that may affect a stable MRC
Safe Mode
Support>
[Enabled, Disabled]
Maximum Maximum frequency (MHz) must divide by 133 or 100
Memory according to RefCLK. In GEAR2 must divide by 2666 or
Frequency> 200. Lowest GEAR2 speed is 2133.
[Auto, 1067, 1200..... 4200, 4267
Max TOULD> Dynamic assignment adjusts TOLUD automatically
based on the largest MMIO length
[Dynamic, 1GB, 1,25 GB, 1.5 GB..... 3.35 GB, 3.5 GB]
SA GV> System Agent Geyserville enables/disables frequency
switching or fix to a specific point.
[Disable, Fixed Low, Fixed Mid, Fixed High, Enabled]
Actively prevent row hammer
Enables RH
Prevention>
[Enabled, Disabled]
Row Hammer Method to prevent row hammer
Solution>
[2x refresh]
Power Down CKE power Down Mode Control
Mode>
[Auto, No Power Down, APD, PPD-DLLoff]
Memory Enables/ disable memory scrambler support
Scrambler>
[Enabled, Disabled]
Force ColdReset>
Force Coldreset or Choose MrcColdBoot mode, when
Coldboot is required during MRC execution- If ME 5 MB,
Force Coldreset is required! [Enabled, Disabled]
Memory Remap> Memory remap above 4 GB
[Enabled, Disabled]
Fast Boot> Fast path through the MRC [Enabled, Disabled]
COMe-cEL6 - User Guide, Rev.1.2
Refresh_
[Disables, 1- Enabled for
2X_ Warm or Hot, 2-
Mode>
Enabled Hot only]
DDR4 When enables MC uses
Thermal MR4 to read DDR4
Sensor> thermal sensors
[Enabled, Disabled]
Self [Enabled, Disabled]
Refresh
Enable>
[Enabled, Disabled]
// 78