Kontron COMe-cEL6 User Manual page 73

Sub-screen Next Level Sub-screens / Description
Hardware
External Fan>
Monitor>
Fan Control>
(continued)
Fan Pulse>
Fan Trip Point
Speed>
Trip Point
Speed>
Reference
Temperature>
5.0V Standby>
Menu Batt Volt at
COMe Pin>
Wider Range
VCC>
Sub-screen Next Level Sub-screens / Description
UEFI Variables Password
Protection> Protection of
Runtime
Variables>
Sub-screen Next Level Sub-screens / Description
Serial Port COM1(PCI Bus0, Dev30, Func1, Port1) (disabled)
Consol
Console Redirection
Redirection>
COM2(PCI Bus0, Dev0, Func0) (disabled)
Console Redirection
Serial port for out of Band management/Windows emergency Management Services (EMD)
Console
Redirection EMS>
Sub-screen Next Level Sub-screens / Description
Read only field
AMI Graphics
Output Protocol
Intel® Graphics Controller / Intel® GOP Driver
Policy>
[18.0.1031]
Output Select>
Bist Enable>
Sub-screen Next Level Sub-screens / Description
SIO Common Lock legacy
Settings> resource>
Sub-screen Next Level Sub-screens / Description
SIO Active Serial
Configuration> port>
www.kontron.com
Sets fan control mode where disable totally stops the fan.[Disabled,
Manual, Auto]
No. Pulses the fan produces during one revolution (range 1 to 4)
[2]
Temperature at which the fan accelerates (range 20 to 80 C)
[50]
Fan speed at trip point in % (30 Min.) Fan always runs at 100% at
TJMax 10 C.[50]
Determines the temperature source used for automatic fan control
[CPU temperature, Module temperature]
Read only field
[5.2 V]
Read only field
[3.02 V]
Read only field
[12.22 V]
Controls NVRA; runtime variable protection through system admin
Password.
[Enabled, Disabled]
[Enabled, Disabled]
Selects output Interface
[eDP1, DVI1]
Starts of stops BIST on the integrated display panel
[Enabled, Disabled]
[Enabled, Disabled]
Use this Device Enable or disable use of this logical device
[Enabled, Disabled]
COMe-cEL6 - User Guide, Rev.1.2
Port is disabled
Port is disabled
// 73