Kontron COMe-cEL6 User Manual page 74

Sub-screen Next Level Sub-screens / Description
SIO Active Serial
Configuration> port>
(continued) (continued)
Warning! Disabling SIO logical devices may have unwanted side effects. Proceed with
caution!
Active Parallel
Port>
Warning! Disabling SIO logical devices may have unwanted side effects.
Proceed with caution!
Warning! Changes made during setup session will be shown after you restart
Sub-screen Next Level Sub-screens / Description
PCI Sub System PCI Settings Common for all Devices:
Settings>
BME DMA
Mitigation>
Change settings of the following PCI devices:
Warnings: Changing the PCI device settings may have unwanted side effects.
System may hang!
Proceed with caution!
Sub-screen Next Level Sub-screens / Description
USB Read only field
Configuration>
USB module version Controller and devices
Legacy Support>
www.kontron.com
Logical Device Read only field
Settings
IO=2F8h; IRQ=3;
Current>
Possible: Use Allows the user to change the device's resource
Automatic settings. New settings are reflected on the setup
Settings> page after system restart.
[Use Automatic Settings,
IO=3F8h; IRQ=4, DMA;
IO=3F8h; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=2F8h; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=3E8h, DMA; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=2E8h; IRQ=3,4,5,7,9,10,11,12; DMA]
Use this Device> Enable or disable use of this logical device
[Enabled, Disabled]
Logical Device Read only field
Settings Current>
IO=378h; IRQ=5;
Possible: Use Allows the user to change the device's resource
Automatic settings. New settings are reflected on the setup
Settings:> page after system restart.
[Use Automatic Settings,
IO=378h; IRQ=5,
IO=378h; IRQ=5,6,7,9,10,11,12
IO=2F8h; IRQ=5,6,7,9,10,11,12,
IO=3E8h, DMA; IRQ=5,6, 7,9,10,11,12
IO=2E8h; IRQ=5,6,7,9,10,11,12]
Mode> [STD Printer Mode, SPP Mode, EPP-1.9 and SPP
mode, EPP-1.7 and SPP mode, ECP Mode, ECP and
EPP 1.9 Mode, ECP and EPP 1.7 mode]
Re-enable Bus master Attribution disabled during PCI enumeration for
PCI Bridge after SMM locked.
[Enabled, Disabled]
Auto: disable legacy if no USB devices are connected
Disable: keeps USB devices available only for EFI applications
[Enabled, Disabled, Auto]
COMe-cEL6 - User Guide, Rev.1.2
// 74