COMh-caAP User Guide
3.7.5 Temperature Sensors
The modules's processor is capable of reading its internal temperature. The on-module Hardware
Monitor (HWM), located in the board management controller KSC20, uses an on-chip temperature
sensor to measure the modules's temperature on the board.
Figure 4: Module Temperature Sensor
1.
Temperature Sensor in Board Management Controller
3.7.6 On-Module Fan Connector
The module's fan connector powers, controls and monitors an external fan. To connect a standard 3-
pin connector fan to the module, use Kontron's fan cable, KAB-HSP 200 mm (96079-0000-00-0).
www.kontron.com
31/60