Kontron COMe-cEL6 User Manual page 72

Sub-screen Next Level Sub-screens / Description
Miscellaneous>
Lid Switch Mode>
(continued)
Sleep Button
Mode>
ACPI Temperature
Polling>
TZ00
Temperature
Polling Time>
Create ACPI AC
adapter>
SMbus Device
ACPI Mode>
CPLD Device ACPI
Mode>
Control COMe
GPIOs in BIOS>
GPIO IRQ#>
I2C IRQ#>
Local FW Update>
Last System
Reset Through>
Sub-screen Next Level Sub-screens / Description
Smart settings> Smart Self test>
Sub-screen Next Level Sub-screens / Description
Hardware Read only field
Monitor>
H/W Monitor type, CPU temperature, and Modules temperature value
CPU Fan>
Fan Control>
Fan Pulse>
Fan Trip Point
Speed>
Trip Point
Speed>
Reference
Temperature>
www.kontron.com
Shows or hides LID switch in ACPI OS.
[Enabled, Disabled]
Shows or hides sleep button in ACPI OS
[Enabled, Disabled]
Sets mode for temperature polling through OSPM
(0:disabled, 1:enabled)
[Enabled, Disabled]
Interval (sec) between two temperature measuring attempts in ACPI
thermal zone 00 (Ambient temperature)
[30]
Creates ACPI AC adapter device with virtual battery even in non-
battery systems. This help some device drivers to identify the power
status of the system.
[Enabled, Disabled]
SM bus device is hidden or visible in OS
[Hidden, Normal]
CPLD device is hidden or visible in OS
[Hidden, Normal]
GPIO control in BIOS- If disable GPIO are not touched by BIOS
[Enabled, Disabled]
Sets IRQ# to trigger by the CPLD on GPIO event.
[Enabled, Disabled]
Sets the IRQ number to trigger by cPLD on I2C event.
[Enabled, Disabled]
Allows BIOS re-flashing if Relax Security Configuration is set as
enabled. Only Valid for one reset cycle!
[Enabled, Disabled]
Read only field
[Other/Software]
Runs Smart Self Test on all HDDs during Post
[Enabled, Disabled]
Sets fan control mode where disable totally stops the fan.
[Disabled, Manual, Auto]
No. Pulses the fan produces during one revolution (range 1 to 4) [2]
Temperature where the fan accelerates. (range 20 to 80 C) [50]
Fan speed at trip point in % (30 Min. Fan always runs at 100% at
TJMax 10 C.[50]
Determines the temperature source used for automatic fan control
[CPU temperature, Module temperature]
COMe-cEL6 - User Guide, Rev.1.2
// 72