Table of Contents
Advertisement
COMh-caRP User Guide
3.7.4 Operating without Kontron Heatspreader Plate (HSP) Assembly
The operating temperature is the maximum measurable temperature on any spot of the module's
surface.
3.7.5 Temperature Sensors
The modules's processor is capable of reading its internal temperature. The on-module Hardware
Monitor (HWM), located in the board management controller KSC20, uses an on-chip temperature
sensor to measure the modules's temperature on the board.
Figure 4: Module Temperature Sensor
1.
Temperature Sensor in Board Management Controller
3.7.6 On-Module Fan Connector
The module's fan connector powers, controls and monitors an external fan. To connect a standard 3-
pin connector fan to the module, use Kontron's fan cable, KAB-HSP 200 mm (96079-0000-00-0).
www.kontron.com
35/79
Advertisement
Table of Contents
