Pushbutton Functions - Datakom D-500 MK2 User Manual

D-500 MK2 User Manual

10.2. PUSHBUTTON FUNCTIONS

BUTTON FUNCTION
Selects TEST mode. The genset runs and takes the load.
Selects MANUAL mode. The RUN pushbutton is enabled. The genset will run when
RUN mode is selected. It can be stopped anytime by depressing the OFF button.
Runs the genset off load. Applicable only in MANUAL mode.
Selects AUTO mode. The genset runs when necessary and takes the load.
Selects OFF mode. The genset stops after cooldown. If depressed again, the genset
will immediately stop.
Selects next display screen in the same display group.
LAMP TEST when held pressed.
Selects previous display group.
Selects next display group.
Selects previous display screen in the same display group.
Resets the ALARM RELAY.
Manual MAINS CONTACTOR (or BUSBAR CONTACTOR) control in RUN mode.
Manual GENSET CONTACTOR (or BUSBAR CONTACTOR) control in RUN mode.
When held pressed for 5 seconds, enters PROGRAMMING mode.
When held pressed for 5 seconds, resets service request counters. Please review
chapter SERVICE REQUEST ALARM for more details.
Makes factory reset. Please review chapter RESETTING TO FACTORY
DEFAULTS for more details.
- 68 -
Firmware V-6.3