Sms Commands - Datakom D-500 MK2 User Manual

D-500 MK2 User Manual

28. SMS COMMANDS

SMS messages are accepted only from phone numbers recorded in the
Communication>GSM>Message Numbers tab.
Answers to SMS messages will be sent to all phone numbers in the list.
SMS messages must be written exactly as below, without any preceding blanks.
Only UPPERCASE characters are permitted.
COMMAND
GET IP
GPRS 1
GPRS 0
RESET
ALARMS
REBOOT
MODEM RESET
GET INFO
DESCRIPTION
If GPRS connection is
active, the controller will
reply by an SMS message
indicating the IP address of
the GSM modem.
Activates the GPRS
connection
Stops the GPRS connection
Clears alarms of the controller.
The operating mode is not
modified.
Performs a hard reset on the
controller
Performs a hard reset on the
modem
Returns the alarm list and
actual measured values
- 158 -
ANSWER
IP: 188.41.10.244
GPRS enabled!
GPRS disabled!
Alarms cleared!
no answer
no answer
ALARMS (if exists)
GEN: Vavg/ıAVG/kWtot/pf/Freq
MAINS: Vavg/ıAVG/kWtot
OIL_PR/TEMP/FUEL%
Firmware V-6.3