Mt-Rj Fiber-Optic Connector And Sfp Module - HP StorageWorks SR2122 User Manual

Installation
The Gigabit Ethernet ports use fiber-optic SFP modules with either MT-RJ
connectors (see
ports use fiber-optic SFP modules with LC connectors (see
Table 3
Ethernet and Fibre Channel ports. See Appendix B, "Cable and Port Pinouts," for
SFP module specifications.
Figure 13: MT-RJ fiber-optic connector and SFP module
34
Because invisible radiation may be emitted from the aperture of
WARNING:
the port when no fiber cable is connected, avoid exposure to radiation and do
not stare into open apertures. To see translated versions of the warning, refer
to the Regulatory Compliance and Safety document that accompanied the
device.
Figure 13) or LC connectors (see
to determine what types of SFP modules you can install in the Gigabit
MT-RJ plug
Caution: Protect your fiber-optic SFP modules by inserting clean dust covers
into the SFPs after the cables are extracted from them. Be sure to clean the
optic surfaces of the fiber cables before you plug them back into the optical
bores of another SFP module. Avoid getting dust and other contaminants into
the optical bores of your SFP modules; the optics will not work correctly when
obstructed with dust.
SFP module
IP Storage Router SR2122-2 User Guide
Figure 14). The Fibre Channel
Figure 14). Refer to