Prerequisite Tasks; Vlan Encapsulation; Configuration Tasks - HP StorageWorks SR2122 User Manual

Configuring VLAN

Prerequisite Tasks

Before configuring for VLAN, make sure you have configured all system
parameters as described in
Chapter 6, "Configuring System Parameters"

VLAN Encapsulation

The storage router uses the IEEE 802.1Q standard for VLAN encapsulation.
Note:
as a trunk port and the encapsulation set to 802.1Q, not Inter-Switch Link (ISL), which is
the default setting for trunk ports.

Configuration Tasks

To configure for VLAN on the storage router:
1. Configure for VLAN using the VLAN Trunking Protocol (VTP) or Configure
2. Configure an IP route.
3. Verify and save configuration.
Note:
performing the configuration tasks. Save your configuration by using the
save all bootconfig CLI command. This command saves all configuration data
to the bootable configuration, which is then used when the storage router is rebooted.
4. Proceed to
Figure 46
without VTP.
112
If the storage router is connected to a switch, the switch port must be configured
for VLAN without using VTP.
You can verify and save the configuration at any point in the process of
Chapter 8, "Configuring SCSI Routing"
and to assign a VLAN to a SCSI routing instance.
contrasts configuring the storage router for VLAN with VTP and
Chapter 5, "Configuring the Storage Router"
to configure SCSI routing
IP Storage Router SR2122-2 User Guide
or