Installing On A Table Or A Shelf; Rack-Mounting The Storage Router - HP StorageWorks SR2122 User Manual

Installing on a Table or a Shelf

You can install the storage router on a table or a shelf (or another flat, secure
surface).
If you are going to install the storage router in an equipment rack, skip this section
and proceed to the
chassis on a table or a shelf:
1. Locate the four adhesive-backed rubber feet in the accessory kit that is
2. Peel the rubber feet from their backing and place the feet onto the four round
3. Place the storage router on a table or a shelf near an AC power source.

Rack-Mounting the Storage Router

You can rack-mount the SR2122-2 in a 19-inch equipment rack with the front
panel forward.
The accessory kit shipped with your storage router contains:
■
■
■
You need the following tools to install the SR2122-2 in a rack:
■
■
To install the SR2122-2 in a rack:
1. Prepare for installation:
IP Storage Router SR2122-2 User Guide
"Rack-Mounting the Storage
shipped with the storage router.
recessed areas on the bottom of the chassis.
two rails
two wing nuts
various screws
Phillips screwdriver
Tape measure
a. Place the storage router on the floor or on a sturdy table as close as
possible to the rack. Leave enough clearance so that you can move around
the storage router.
b. Use a tape measure to measure the depth of the rack. Measure from the
outside of the front mounting uprights to the outside of the rear mounting
uprights. The depth must be at least 19 inches (48.26 cm) but not more
than 32 inches (81.3 cm).
Router" section. To install the
Installation
29