Running The Setup Configuration Wizard - HP StorageWorks SR2122 User Manual

Running the Setup Configuration Wizard

The Setup Configuration Wizard is available from the CLI and is a script
consisting of a series of prompts asking you to enter values to provide a basic
system configuration for your storage router. You will be asked to enter values to
configure the following:
■
■
■
■
■
■
■
You can run the Setup Configuration Wizard through an EIA/TIA-232 console
interface connection, or through a Telnet session using the management interface
if the IP address is already configured in the storage router. If you choose to
complete the configuration using the management interface, use the default
password, hp, to establish your CLI session.
The values entered for the Setup Configuration Wizard are saved at the end of the
wizard script. To quit the configuration wizard at any time without saving
changes, press Ctrl-C, and reboot the storage router to restore previous values.
Note:
number assigned by IANA. You can change this value for your network configuration if
needed. See the
Reference Guide
IP Storage Router SR2122-2 User Guide
Management interface — includes primary and secondary DNS servers
Date and time — includes time zone and NTP server
Network management access — includes SNMP
Management access — includes passwords and system administrator contact
information
System administrator contact information
SCSI routing — this section of the wizard only appears if SCSI routing was
the configuration deployment selected in the initial system configuration
script; if you are using the VLAN service, do not configure SCSI routing with
the Setup Configuration Wizard
FCIP — this section of the wizard only appears if FCIP was the configuration
deployment selected in the initial system configuration script
The factory default listening port used for iSCSI traffic is 3260. This is a port
HP StorageWorks IP Storage Router 2122-2 Command Line Interface
for details.
Configuring the Storage Router
89