Installing A Memory Module - HP A6602 Installation Manual

Figure 6-23 Remove the memory module
Do not touch the surface-mounted components of the memory module directly with your hands.

Hold the memory module only at its non-conductive edge. Because a memory module is
vulnerable to ESD, improper operation may damage it.
Do not use excessive force in operation. Otherwise, the release latches at both ends will get

damaged.
To protect the removed memory module, place it in an antistatic bag.


Installing a Memory Module

Follow these steps to install a memory module:
Step1 Make sure all power supplies to the router are disconnected.
Step2 Align the polarization notch of the memory module with the key in the memory module slot.
Step3 Position the memory module so that it is perpendicular to the main board and insert the
memory module into the memory module slot.
Step4 Carefully and firmly press the memory module at both ends until you hear a click. This indicates
the memory module is seated in the memory module slot.
Step5 Check that the release latches have firmly locked the memory module in position.
Figure 6-24 Install the memory module
Do not touch the surface-mounted components of the memory module directly with your hands.
Hold the memory module only at its non-conductive edge. Because a memory module is
vulnerable to ESD, improper operation may damage it.