Configuring The Management Interface; System Parameters Example Configuration - HP StorageWorks SR2122 User Manual

Note:
save system bootconfig or save all bootconfig command) at any
point in the process of performing the configuration tasks.
Figure 45
Cluster Name: Mt_Olympus
Figure 45: System parameters example configuration

Configuring the Management Interface

Configuring the management interface consists of tasks for setting the system
name, IP address and mask, gateway, and DNS servers. Use the following
procedure to configure the management interface.
If you want external servers, such as RADIUS, TACACS+, or SMTP servers, to
communicate with the SR2122-2 via a specific IP address on a Gigabit Ethernet
interface (for in-band management), configure the IP address on the desired
Gigabit Ethernet interface as described in Step 4. Save the changes to the bootable
configuration (save all bootconfig) and then reboot the storage router.
Note:
addresses and all names given below are examples only.
IP Storage Router SR2122-2 User Guide
You can verify and save the configuration (by using the
illustrates the example configuration used in this chapter.
HA interface
HP SR2122-2
IP: 10.1.20.56
Mask: 255.255.255.0
HA
HP SR2122-2
The purpose of Figure 45
Management interface
System Name: SR_2122-MG1
Domain Name: mystoragenet.com
IP: 10.1.10.244
Mask: 255.255.255.0
Management
Station
IP: 10.1.30.17
Gateway
Mgmt
IP: 10.1.10.201
Primary
DNS server
IP: 10.1.40.243
Secondary
DNS server
IP: 10.1.50.249
NTP server
IP: 10.1.60.86
is an example system configuration only. The IP
Configuring System Parameters
15041
99