Connecting Power; Power Set To Off; Connecting A Power Cord To The Power Connector - HP StorageWorks SR2122 User Manual

Installation

Connecting Power

The SR2122-2 can be connected to either of two power sources: 115-120 VAC/60
Hz or 230-240 VAC/50 Hz. The power supply automatically senses the source and
adjusts to either source.
To connect power to the storage router:
1. Make sure the power switch is set to Off.
Figure 27: Power set to Off
2. Plug the power cord into the power receptacle located on the rear panel in the
Figure 28: Connecting a power cord to the power connector
3. Connect the other end of the power cord to the power source for the storage
46
chassis.
router.
IP Storage Router SR2122-2 User Guide