Prerequisite Tasks; Configuration Tasks - HP StorageWorks SR2122 User Manual

Configuring System Parameters

Prerequisite Tasks

Before configuring system parameters, make sure you have finished the following
tasks:
■
■
Note:
complete IP Storage Router Setup Configuration Wizard (using the setup CLI
command with no keyword), or if you ran the wizards separately using all the setup
CLI commands except setup scsi. However you may wish to perform some of the
optional configuration procedures described in this chapter such as configuring IP
routes or SSH access.

Configuration Tasks

Note:
To configure system parameters on your storage router:
1. Configure the management interface.
2. Configure the time and date.
3. Configure IP routes. (Optional)
4. Configure network management access. (Optional)
5. Configure passwords.
6. Configure administrator contact information. (Optional)
7. Configure the high-availability (HA) interface. (Optional)
8. Configure for Secure Shell (SSH) access. (Optional)
9. Configure for iSNS communications. (Optional)
10. Verify and save configuration.
98
Completed the hardware installation according to the storage router Hardware
Installation Guide
Entered values as requested by the initial system configuration script (for
more information, see
You do not need to perform the configuration tasks in this chapter if you ran the
All configuration tasks require Administrator mode access to the storage router.
"Initial System Configuration Script" on page 88)
IP Storage Router SR2122-2 User Guide