With Vlan; Configuring Iscsi Targets - HP StorageWorks SR2122 User Manual

Configuring SCSI Routing

With VLAN

To assign a server interface and VLAN to a SCSI routing instance:
1. enable — Enter Administration mode.
2. SCSIRouter zeus serverif ge2 VLAN 100 10.1.0.45/24 —
Note:
column.

Configuring iSCSI Targets

Configuring iSCSI targets consists of specifying the SCSI routing instance to
which an iSCSI target is to be assigned, specifying the iSCSI target, and mapping
the iSCSI target to a physical storage device. When assigning an iSCSI target, you
can specify the physical storage device either by physical storage address, serial
number, or by an index number assigned to the device.
Note:
need to configure access to newly created iSCSI targets according to the "Configuring
Access" section later in this chapter.
Use the procedures that follow according to mapping type and storage addressing
type:
■
■
■
■
126
Assign a VLAN, identified by its VID 100, to the desired SCSI routing
instance zeus. Specify the server interface ge2 and the IP address and subnet
mask 10.1.0.45/24 that the VLAN will use to access the SCSI routing
instance. In this example, the subnet mask of 255.255.255.0 was set using
CIDR style /24.
To look up the VID, use the show vlan command. VIDs are listed in the VLAN
When a new iSCSI target is configured, IP hosts do not have access to it. You
Target-and-LUN mapping using WWPN addressing
Target-and-LUN mapping using LUNWWN addressing
Target-and-LUN mapping using Serial Number addressing
Target-only mapping using WWPN addressing
IP Storage Router SR2122-2 User Guide