Advertisement
3
Set the [Position] button in the [Position] group to the
on state and set the following parameters.
No.
Parameter
a)
1
H
2
V
a) Not displayed when a 2-channel mode Brick pattern (pattern
numbers 2801 to 2804, 2811 to 2814) is selected.
When a 2-channel mode P in P pattern (pattern
numbers 2651, 2652) is selected, set the relative
position using the following parameters.
No.
Parameter
4
Relative H
5
Relative V
To return the pattern position to the center of the
screen
Press the [Center] button in the [Position] group.
Displaying/moving the DME wipe pattern
position (Position Select)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Modify menu (11109.45).
2
In the [Ch Select] group, select the target DME
channel to set.
3
In the [Position Select] group, select a move position.
Top Left: Top left corner
Top Right: Top right corner
Bottom Left: Bottom left corner
Bottom Right: Bottom right corner
The button for the current pattern position is in the on
state. When the pattern position is at the center of the
screen, all four buttons are in the on state.
Note
When multiple channels are selected, the 1st channel
becomes the target for movement.
Setting the DME wipe pattern size (Size)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Modify menu (11109.45).
Adjustment
Horizontal position
• Negative values move left.
• Positive values move right.
Vertical position
• Negative values move
down.
• Positive values move up.
Adjustment
Relative position in the
horizontal direction
Relative position in the
vertical direction
2
In the [Ch Select] group, select the target DME
channel to set.
3
Set the [Size] button to the on state and set the
following parameter.
No.
Parameter
1
Size
Note
When multiple channels are selected, the setting
values for the channel with the lowest number are
displayed. When you adjust the setting values, this
adjusts the settings on the other channels by the same
amount.
Setting the DME wipe pattern cropping
(Crop)
1
Open the Home > M/E-1 > Bus/Transition > DME
Wipe > Modify menu (11109.45).
2
In the [Ch Select] group, select the target DME
channel to set.
3
Set the [Crop] button in the [Crop Mode] group to the
on state and set the following parameters.
No.
Parameter
1-1
H
1-2
V
1-3
All
2-1
Top
2-2
Left
2-3
Right
2-4
Bottom
Note
When multiple channels are selected, the setting
values for the channel with the lowest number are
displayed. When you adjust the setting values, this
adjusts the settings on the other channels by the same
amount.
To crop to 4:3 aspect ratio
Press the [4:3 Crop] button in the [Crop Mode] group.
169
Adjustment
Size
Adjustment
Simultaneous adjustment of
crop of left and right edges
Simultaneous adjustment of
crop of top and bottom edges
Simultaneous adjustment of
crop of top, bottom, left, and
right edges
Crop of top edge
Crop of left edge
Crop of right edge
Crop of bottom edge
Advertisement
Chapters
