Advertisement
When second delegation mode is disabled
In a 36-button row, the button numbers are as follows.
Button
Button number
when the [SHIFT]
button is off
1st row and 3rd
1 to 35
row:
1st (left side) to
35th buttons
2nd row and 4th
–
row:
1st (left side) to
35th buttons
The rightmost (36th) button is used as the [SHIFT]
button.
When selecting the bus/signal of button numbers 1 to 35
in the 1st row and 3rd row, press the corresponding
number button.
When selecting the bus/signal of button numbers 36 to 70
in the 2nd row and 4th row, press the corresponding
number button.
When selecting the bus/signal of button numbers 36 to 70
in the 1st row and 3rd row, press and hold the [SHIFT]
button and press the corresponding number button.
[SHIFT] button
The [SHIFT] button has two operation modes.
Hold mode: Mode where the shifted state is selected
while the button is pressed
Lock mode: Mode where every time the button is pressed,
it toggles between the shifted state and unshifted state
In cross-point button rows (3rd row/4th row), you can
also disable the shift button function.
For details about setting delegation button rows, see
"Setting the operation mode of the shift button"
(page 404).
For details about setting cross-point button rows, see
"Setting the [SHIFT] button operation mode"
(page 380).
Notes
• When second delegation is disabled, the 1st row and 3rd
row shift buttons are set to hold mode (fixed). You can
select the button number in the shifted state while
pressing the shift button.
The 2nd row and 4th row are always in the shifted state,
hence the shift buttons cannot be operated.
• The rightmost button operates as a cross-point button
when the [SHIFT] button use is disabled in the cross-
point button row.
In a 36-button row, it becomes button number 36.
Cross-Point Button Display
Button number
Source name of signals
when the [SHIFT]
button is on
You can attach a name (source name) to the signal
36 to 70
assigned to a cross-point button, with a maximum of 16
characters.
The specified source name appears on the display of the
cross-point control block/AUX bus control block (AUX
36 to 70
bus operation mode). When a signal in the shifted state of
a cross-point button is selected, the source name of the
shifted-state signal is displayed.
Six types of display mode can be set according to the
information to display. The display mode can be switched
using the following buttons.
• ICP-X7000: Select display mode 1 to 6 using the
• ICP-X1000 series: The display mode switches each
Colors of lit cross-point buttons
In a single cross-point button row, only the last pressed
button is active, and is lit amber or red.
Color of
button when
lit
Amber
Red
When second delegation mode is enabled on the AUX bus
control block, 4th row cross-point buttons are lit green in
the low tally state.
Cross-point indicators
When lit, these indicate the source color of the video
signal assigned to buttons on the 3rd row of the cross-
point control block/AUX bus control block (AUX bus
operation mode).
The color of the cross-point indicators does not change
even if a 3rd row button is lit red or amber.
Cross-Point Hold
Setting cross-point hold enables you to recall an effect
timeline or snapshot while keeping the current cross-point
selection unchanged.
89
display mode buttons assigned to the cross-point pad.
time the [DISP MODE] button assigned to the function
button section is pressed.
Button state
Low tally
Selected signal is not included in the final
output image
High tally
Selected signal is included in the final
output image
Note
Advertisement
Chapters
