Advertisement
Note
When an operation mode that supports configuration of
transitions where keys are inserted/removed
independently is set, the transition type for inserting and
removing keys can be set separately.
For details about independent key transition operation
mode, see "Setting the Independent Key Transition
Mode" (page 390).
Setting the independent key transition
type (Flexi Pad control block)
You can set the independent key transition type using the
Flexi Pad control block of the target switcher bank.
1
Press the [KEY] button.
The memory recall section switches to key operation
mode.
2
Select the target key to set.
Press a [KEY1] to [KEY8] button, turning it on.
3
Select a transition type.
Press the [MIX] button, [WIPE] button, or [DME
WIPE] button, turning it on.
In operation modes that support configuration of
transitions separately for when keys are inserted/
removed, configuration while a key is not inserted
sets the transition type for key insertion and
configuration while a key is inserted sets the
transition type for key removal.
4
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Setting the
Independent Key Transition Rate" (page 110).
When a wipe is selected
Set the wipe pattern.
For details, see "Setting an Independent Key
Transition Wipe" (page 158).
When a DME wipe is selected
Set the DME wipe pattern.
For details, see "Setting an Independent Key
Transition DME Wipe" (page 171).
Setting the independent key transition
type (key fader control block)
You can set the independent key transition type for a key
assigned to a key delegation button.
For details about assigning key delegation buttons, see
"Assigning Control Panel Buttons" (page 397).
1
Select the target key to set.
Press a key delegation button, turning it on.
2
Select a transition type.
Press the [MIX] button, [WIPE] button, [DME
WIPE] button, or [CUT] button, turning it on.
In operation modes that support configuration of
transitions separately for when keys are inserted/
removed, configuration while a key is not inserted
sets the transition type for key insertion and
configuration while a key is inserted sets the
transition type for key removal.
When you press and hold the [SHIFT] button and
press the independent key transition type selection
button, you can set the transition type for key removal
while a key is not inserted and the transition type for
key insertion while a key is inserted.
3
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Setting the
Independent Key Transition Rate" (page 110).
When a wipe is selected
Set the wipe pattern.
For details, see "Setting an Independent Key
Transition Wipe" (page 158).
When a DME wipe is selected
Set the DME wipe pattern.
For details, see "Setting an Independent Key
Transition DME Wipe" (page 171).
Setting the independent key transition
type (menu)
This section describes the M/E-1 key 1 menu as an
example.
1
Open the Home > M/E-1 > Key1 > Transition >
Transition Type menu (11101.51).
109
Advertisement
Chapters
