Sony XVS-G1 User Manual page 244

Output level
Black
balance
adjustment
Output level
Gamma
correction
Knee correction
1
Open the Home > Other Effects > Aux Bus > Aux
Bus CCR menu (18102.21).
2
Select the target AUX bus to set.
3
Set the [Primary CCR] button in the [Primary CCR]
group to the on state.
4
In the [Primary CCR Adjust] group, select an
adjustment item.
Black: Black balance adjustment
White: White balance adjustment
Gamma: Gamma correction
Knee: Knee correction
5
Set the following parameters.
White balance
adjustment
Input level
Input level
Unadjusted signal
Adjusted signal
244
No. Parameter
1 Red
2 Green
3 Blue
4 All
a) [Red] parameter value is shown.
To return primary color correction settings to
the defaults
Press the [Unity] button in the [Primary CCR] group,
check the message, then press [OK].
Setting RGB clip
1
Open the Home > Other Effects > Aux Bus > Aux
Bus CCR menu (18102.21).
2
Select the target AUX bus to set.
3
Set the [RGB Clip] button in the [RGB Clip] group to
the on state.
4
In the [RGB Clip Adjust] group, select an adjustment
item.
Dark: Dark clip adjustment
White: White clip adjustment
5
Set the following parameters.
No. Parameter
1 Red
2 Green
3 Blue
4 All
a) [Red] parameter value is shown.
To return the RGB clip settings to the defaults
Press the [Unity] button in the [RGB Clip] group, check
the message, then press [OK].
Enabling a link group
When a link group is enabled, selecting a specific AUX
bus and setting the color corrector will apply the settings
of all the AUX buses in the same link group.
You can temporarily disable a link group to set individual
settings for AUX buses within the link group.
For details about setting a link group, see "Setting a
Color Corrector Link Group" (page 438).
Adjustment
R signal adjustment
G signal adjustment
B signal adjustment
Simultaneous adjustment of
a)
all RGB signals
Adjustment
R signal adjustment
G signal adjustment
B signal adjustment
Simultaneous adjustment of
a)
all RGB signals