Advertisement
Auto pause insert mode
In addition to the auto insert mode function, auto pause
insert mode automatically inserts a pause event between
events.
The time between an event being inserted and the next
event being inserted is set as the pause time.
Note
When macros are merged, pause events are not
automatically inserted.
Executing a Macro
Pausing and resuming a macro
Pause event
You can insert a pause event to pause macro execution.
This is useful for adjusting the event execution timing.
You can set a pause time in the range of 0 to 999 frames.
When the set pause time elapses, macro execution
automatically resumes.
When the pause time is set to "0", macro execution does
not automatically resume. You can resume with arbitrary
timing using the take operation.
Note
When registering a rewind or move to start point
operation as an event for an external device, you must
take into account the time taken to complete execution.
Adjust the timing by inserting a pause event.
Take operation
This operation is used to resume execution of a paused
macro.
A take operation is done using the following buttons.
• [TAKE] button in macro operation mode in the Flexi
Pad control block
• [TAKE] button assigned to the cross-point pad in the
cross-point control block
• [MCRO TAKE] button assigned to the transition
control block (simple type)
• Button assigned with the "Macro Take" utility
command
Macro execution mode
The following two types of execution mode can be set.
For details about setting the execution mode, see "Setting
the macro execution mode" (page 416).
Normal execution mode
When execution of an event ends, the next event is
automatically executed.
Step execution mode
When execution of an event ends, execution is paused.
The next event is executed by a take operation.
Executing multiple macros
simultaneously (multi mode)
Normally, a single macro can be executed at a time, but
enabling multi mode allows multiple macros to be
executed.
For details about setting multi mode, see "To enable
simultaneous execution of multiple macros" (page 416).
Simultaneous execution of multiple macros is supported
only when macro registers are recalled using the
following buttons.
• Cross-point buttons of the cross-point control block
configured with a macro attachment
• Cross-point buttons of the cross-point control block
assigned with macro register recall function
• Memory recall buttons in the utility/shotbox control
block assigned with macro register recall function
• Memory recall buttons in the utility control block
assigned with macro register recall function
Notes
• In multi mode, macros are executed in normal
execution mode, regardless of the execution mode
setting.
• Up to 16 macros can be executed simultaneously.
• When multi mode is enabled, macro editing is
supported only when a register is recalled using the
following operations.
– Buttons in the Flexi Pad control block
– Buttons in the numeric keypad control block
– Buttons in cross-point pad in the cross-point control
block
– GPI input
– Menu
• If operations due to events executing simultaneously
conflict with each other, the events may not be
reproduced with the registered settings or sequence.
• To resume all paused macros within the macros
executed simultaneously, press the button assigned
with the "Macro All Take" utility command.
• To stop all macros executed simultaneously, press the
button assigned with the "Macro All Cancel" utility
command.
307
Advertisement
Chapters
