Advertisement
In frame number input mode, enter three digits. In
timecode input mode, enter four digits.
To delete the entered value
Press the [CLR] button.
Note
You can also enter a difference value from the
currently set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 77).
4
Press the [ENTER] button.
The entry is applied and the set value is reflected on
the memory recall button in the utility/shotbox
control block.
Setting the transition rate (menu)
This section describes the M/E-1 menu as an example.
1
Open the Home > M/E-1 > Bus/Transition >
Transition > Transition Type menu (11109.21).
2
Select a transition type in the [Transition Type]
group.
3
Set the transition rate using the following parameter.
No.
Parameter
1
Transition Rate
To set the transition rate in list view
You can set the transition rate in transition rate list view
on each switcher bank.
1
Open the Home > Utility > Transition Rate menu
(18201.21).
The transition rate for common transitions and
independent key transitions is displayed for each
switcher bank.
2
Select the target switcher bank to set.
3
Press the [Common] button and enter a transition rate
in the numeric keypad window.
In multi program 2 mode, enter a transition rate for
main using the [Common] button, and a transition
rate for sub using the [Sub Common] button.
Adjustment
Transition rate
Executing a Transition
Transitions are executed using the transition control block
or simple-type transition control block.
You can also execute auto transitions using the menu.
Note
In the simple-type transition control block, only
background transition operations are supported.
The buttons used for executing a transition must be
assigned to the transition control block (simple type)
beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 397).
ICP-X7000 transition control block
AUTO TRANS button
101
CUT button
Fader lever
Transition indicator
Advertisement
Chapters
