Advertisement
You can select wipe snapshot registers (1 to 10) using the
buttons in the memory recall section.
The wipe pattern icon is displayed on buttons for registers
with a registered snapshot.
The register number is displayed on buttons for registers
without a registered snapshot.
The wipe pattern number is displayed on the top right
button in the memory recall section.
The button color varies as follows, according to the
register state.
Gray characters: Register not containing a registered
snapshot
White icon/text: Register containing a registered snapshot
Lit orange: Last recalled register
Notes
• The register name is displayed instead of the wipe
pattern icon on buttons for registers with a registered
snapshot. The register number is displayed if a register
name has not been configured.
For details about setting the button display, see
"Setting the button display in wipe snapshot operation
mode/DME wipe snapshot operation mode"
(page 414).
• When both the main pattern and sub pattern are selected
for a pattern mix, the main pattern icon is displayed.
Selecting a wipe pattern
1
Press the [WIPE] button.
The memory recall section switches to wipe snapshot
operation mode.
2
Press the [PTN NO.] button.
The memory recall section switches to numeric
keypad mode.
3
Enter a pattern number and press the [ENTER]
button.
The memory recall section returns to wipe snapshot
operation mode. The selected pattern number is
displayed on the top right button in the memory recall
section.
Saving a wipe snapshot
Set a wipe and save a wipe snapshot register using the
following procedure.
1
Press the [WIPE] button.
The memory recall section switches to wipe snapshot
operation mode.
2
Press and hold the [WIPE] button and press the button
for the target register to save.
The register button is lit orange and the wipe settings
are saved in the snapshot.
Note
If you press a register button in which a wipe
snapshot is already saved, the register data will be
overwritten.
Recalling a wipe snapshot
1
Press the [WIPE] button.
The memory recall section switches to wipe snapshot
operation mode.
2
Press the button for the target register to recall.
The register button is lit orange and the wipe snapshot
is recalled.
To undo a register recall
To undo a recall immediately after recalling a register,
press the [UNDO] button.
Deleting a wipe snapshot
1
Press the [WIPE] button.
The memory recall section switches to wipe snapshot
operation mode.
2
Press and hold the [DEL] button and press the button
for the target register to delete.
The wipe snapshot is deleted and the register button
changes to register number display.
Wipe Snapshot Operations (Menu)
The same memory recall buttons as in the memory recall
section of the Flexi Pad control block are displayed in the
Bus/Transition > Wipe > Wipe Snapshot menu on the
switcher bank. The settings and display of the memory
recall buttons in the Flexi Pad control block and in the
menu are linked.
This section describes the M/E-1 menu as an example.
Selecting a wipe pattern
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Wipe Snapshot menu (11109.37).
161
Advertisement
Chapters
