Advertisement
When single color is selected, set the following
parameters.
No.
Parameter
1
LUM
2
SAT
3
HUE
When mix is selected, set the following parameters.
No.
Parameter
1-1
LUM
1-2
SAT
1-3
HUE
1-4
SIZE
1-5
SOFT
2-1
LUM
2-2
SAT
2-3
HUE
2-4
SIZE
2-5
SOFT
To set a key fill bus signal
Press the [MAT FILL] button, turning it off.
For details about selecting a signal, see "Selecting a
Key Fill Signal/Key Source Signal" (page 90).
2
Set the key source signal using the [AUTO SEL]
button/[SPLT] button.
To set the same signal as the key fill bus (self
mode)
Press the [AUTO SEL] button and [SPLT] button
simultaneously, turning them off.
To set the signal assigned in pair with the key fill
bus signal (auto select mode)
Press the [AUTO SEL] button, turning it on.
To set a different signal than the key fill bus pair
signal (split mode)
Press the [SPLT] button, turning it on.
For details about selecting a signal, see "Selecting a
Key Fill Signal/Key Source Signal" (page 90).
Selecting SL Key Content
You can load content into an SL key to use as a key fill/
key source.
You can select still image content in which a video signal
and key signal have been combined as a key fill/key
source.
Adjustment
Luminance
Saturation
Hue
Adjustment
Color 1 luminance
Color 1 saturation
Color 1 hue
Pattern size
Softness of the pattern
contour
Color 2 luminance
Color 2 saturation
Color 2 hue
Pattern size
Softness of the pattern
contour
For details about content operations, see "Content
Operations" (page 348).
This section describes the M/E-1 key 5 menu as an
example.
Note
Content loading and unloading operations are common to
the key 5 to key 8 menus. Content cannot be loaded/
unloaded individually for each key.
Loading content
You can load content into SL key memory from content
storage.
Note
If the system signal format is different than the image
size, the following processing occurs with the origin at
the top left of the image.
– If an image size is smaller, the missing part is filled
with black.
– If an image size is larger, the excess part is cropped and
removed.
Even when image size processing occurs, the thumbnail
image is not changed.
1
Open the Home > M/E-1 > Key5 > SL Key > Load
menu (11105.61).
Content can be displayed in list view or thumbnail
view.
To change content properties
Press the [Edit Properties] button and edit the
properties in the [Edit Properties] window.
For details, see "Editing Content Properties"
(page 352).
2
Select content to load.
To select and load multiple content, place a check
mark beside the target content to load.
To select and load all content, place a check mark in
the Select All checkbox.
3
Press the [Load to Memory] button.
4
Check the message, then press [OK].
126
Advertisement
Chapters
