Advertisement
Executing a Macro
You can execute a macro using the Flexi Pad control
block, utility/shotbox control block, utility control block,
cross-point control block, or numeric keypad control
block.
On the utility/shotbox control block, utility control block,
and cross-point control block, use buttons assigned with
the macro register recall function.
For details about assigning a function, see "Assigning a
Utility Function" (page 400).
Executing a Macro (Flexi Pad
Control Block)
You can recall a macro register and execute a macro on
the Flexi Pad control block in macro operation mode.
The macro execution operation varies depending on the
execution mode.
For details about the execution mode, see "Macro
execution mode" (page 307).
Notes
• Multi mode is disabled if a macro register is recalled
using the Flexi Pad control block. Only one macro can
be executed at a time.
For details about multi mode, see "Executing multiple
macros simultaneously (multi mode)" (page 307).
• If the same macro or another macro is recalled during
macro execution or when the macro is stopped, the
operation varies depending on the settings.
For details about settings, see "Setting the Macro
Mode" (page 416).
• Events registered in a macro are executed according to
the setup and the device configuration in force when the
events were registered. If the state has changed since
registration, the contents of the macro may not be
reproduced correctly when the macro is recalled.
• When executing a macro, if you switch to macro edit
mode, the macro currently being executed stops.
• A macro cannot be executed while creating/editing a
macro.
Executing a macro in normal execution
mode
1
Press the [MCRO] button.
The [MCRO] button is lit amber, and the memory
recall section switches to macro operation mode.
2
Select a bank.
For details about selecting a bank, see "Selecting a
bank" (page 309).
3
Press the button for the target register to recall.
For details about selecting a register, see "Selecting
a register" (page 309).
The register button is lit orange and the macro is
executed.
The number of executed events and total number of
events are displayed on the bottom center button in
the memory recall section.
To resume when paused by a pause event
When paused by a pause event with a specified pause time
of "0", the [TAKE] button is displayed in the memory
recall section.
Press the [TAKE] button to resume macro execution.
Executing a macro in step execution
mode
1
Press the [MCRO] button.
The [MCRO] button is lit amber, and the memory
recall section switches to macro operation mode.
2
Select a bank.
For details about selecting a bank, see "Selecting a
bank" (page 309).
3
Press the button for the target register to recall.
For details about selecting a register, see "Selecting
a register" (page 309).
The register button is lit orange.
4
Press the [TAKE] button in the memory recall
section.
A single event registered in the macro is executed,
then execution stops.
Press the [TAKE] button to execute events one at a
time.
The number of executed events and total number of
events are displayed on the bottom center button in
the memory recall section.
321
Advertisement
Chapters
