Advertisement
Selecting and Displaying
Regions
The term "region" refers to blocks classified by specific
functions.
In effect timelines and snapshots, you can select target
regions to save/recall registers. You can also select
multiple regions simultaneously.
Types of Regions
The regions are classified as follows.
• Switcher bank regions:
M/E-1 to M/E-5, P/P, M/E-1 Sub to M/E-5 Sub, P/P
Sub
• User regions:
User 1 to User 8
• DME regions:
DME 1 to DME 4 (including DME Global)
• External device regions:
Device 1 to Device 12, P-Bus, GPI, Macro, Router
Notes
• In an effect timeline, regions other than Router are the
target.
• In a snapshot, regions other than Device 1 to Device 12,
P-Bus, GPI, and Macro are the target.
User regions
You can optionally assign the following regions to User 1
to User 8.
The user regions shown in parenthesis are the default
assignments.
• Color Bkgd 1, Color Bkgd 2 (User 1)
• Aux 1 to Aux 48 (User 2)
• Clip Player 1 to Clip Player 4 (User 3)
• Frame Memory 1 to Frame Memory 16 (User 4)
For details about assigning a user region, see "Setting a
User Region" (page 387).
Reference regions
When multiple regions are selected, the reference region
is the display target in the menu.
When a reference region is removed from the target, the
reference region will be set according to the following
order of priority.
M/E-1 > M/E-1 Sub > M/E-2 > M/E-2 Sub > M/E-3 >
M/E-3 Sub > M/E-4 > M/E-4 Sub > M/E-5 > M/E-5 Sub
> P/P > P/P Sub > User 1 > User 2 > User 3 > User 4 >
User 5 > User 6 > User 7 > User 8 > DME 1 > DME 2 >
DME 3 > DME 4 > Device 1 > Device 2 > Device 3 >
Device 4 > Device 5 > Device 6 > Device 7 > Device 8 >
Device 9 > Device 10 > Device 11 > Device 12 > P-Bus
> GPI > Macro > Router
Selecting a Region
When selecting the target region in the menus for effect
timelines and snapshots, the region selection window
appears.
Notes
• The display of the region selection window varies
depending on the menu.
• An effect timeline/snapshot region or other region can
be selected using the numeric keypad control block.
For details, see "Selecting a region" (page 257).
Region display section
Region selection buttons
When separate pages are displayed for each type of
region, select a tab to switch the display.
To select a region, press the target region selection button,
turning it on. A blue bar is displayed across the bottom of
the button.
To cancel a selection, press the target region selection
button, turning it off.
To select all regions
You can press the [All Regions] button to select all
regions configured beforehand at the same time.
If you press the [All Regions] button while none of the
configured target regions are selected, then the target
regions are selected at the same time and all other regions
are deselected.
If you press the [All Regions] button while at least one of
the configured target regions is selected, all regions are
deselected.
For details about setting the regions selected
simultaneously, see "Setting Regions Selected
Simultaneously" (page 397).
78
All Regions button
Advertisement
Chapters
