Table of Contents
Advertisement
AQUATRAN Model 3/40 Operator's Manual
Chapter 2: Setting Up
This chapter provides information on how to set up an AQUATRAN Model 3/40 and prepare it for use.
Read this chapter to learn about:
Unpacking the System
•
•
Preparing for System Installation
•
Front Panel Parts and Controls
•
Inner Chamber Parts and Controls
Back Panel Parts and Controls
•
Connecting nitrogen and compressed air lines to the instrument
•
Unpacking the System
Each AQUATRAN Model 3/40 instrument is shipped in its own crate. Any optional kits or accessories may
be shipped in the instrument crate or in separate cartons. A checklist will be included for the instrument and
any of the optional kits you may have purchased.
If any components are missing or damaged please call MOCON in the USA at (763) 493-6370.
Preparing for Installation
The Site Preparation Instructions (Appendix A) contain important information about preparing a location for
the instrument and the facilities required for your new instrument. Please read Appendix A before
proceeding with the installation of the AQUATRAN Model 3/40.
The ambient environmental conditions in which the instrument will be used must meet those specified on
page 10-1 in Chapter 10.
The AQUATRAN Model 3/40 should be placed on a bench or table capable of supporting approximately
102 kg (225 lbs). The work surface should be flat, clean and free of excessive vibration.
If installing a printer that will be directly connected to the AQUATRAN Model 3/40, place it next to the
instrument. Read the manual that came with the printer for installation procedures.
Do not plug the instrument or printer into a power source until all components have been set up and
connected.
Before proceeding with the setup or operation of the instrument familiarize yourself with the locations and
names of the parts and controls on the front and rear of the instrument.
MOCON, Inc.
Revision D
Setting Up
2-1
Advertisement
Table of Contents
